When you have a naked vape, it’s time to get creative and make a fun and unique vape for your family or friends.
This week’s post is about how to make your own naked vape.
It’s not quite as easy as you think.
Here’s how it works:Step 1: Put the battery in the bowl of a glass or ceramic bowl (we used the same one we used for our naked vape).
Step 2: Take the bowl and place it in the fridge for a few hours.
Step 3: Take out the bowl from the fridge and place the bowl in the freezer.
Step 4: Take a paper towel and wipe the bowl clean.
Step 5: Take another paper towel, and wipe off the bowl.
Step 6: Take your new bowl and wipe it dry.
Step 7: Take an ice cube tray and place on the table in front of you.
Step 8: Place the bowl on the ice cube.
Step 9: Place your bowl in a warm spot in the refrigerator.
Step 10: Put your bowl on a heat source, such as the oven, and turn it on.
Step 11: Wait at least five minutes for the bowl to cool down.
Step 12: Put a glass of water on top of the bowl, and place a piece of tape over the bowl so that you don’t drip the water onto your fingers.
Step 13: Take one of your hands and dip the bowl into the water, making sure that the water is not wet.
Step 14: Take both hands and gently squeeze the water into the bowl while slowly rolling it in.
Step 15: When the bowl has settled, it is ready to vape.
You can use any glass or stainless steel bowl for this, but we used a ceramic bowl for our experiment.
Put the bowl away from the bowl when it’s done cooling.
Take out a paper or plastic wrap and put it in a freezer.
You might have to make several passes to get the bowl completely dry, but it’s very easy.
Step 03: Take two of your disposable ice cubes and put them in the bottom of your bowl.
It will help to hold the bowl steady while you roll it in your hand.
Step 04: Put an ice bag on top.
Step 05: Roll the bowl around the ice bag.
The bowl should be slightly sticky, but not completely dripping with water.
Step 06: Put another ice cube on top and slowly roll it over the ice, to keep it moist.
Step 07: Put two ice cubes on top, one over each end of the ice pack.
Step 08: Roll over the other ice pack until the bowl is completely dry.
It is now ready to use.
Step 09: Wrap the bowl with a paper wrap, and wrap the bowl tightly around your vape.
This will help prevent the bowl not being fully submerged when you fill it.
Step 02: Place it in an empty glass or jar.
Step 01: Place a piece on top for the bottom.
Step 0: Wait until it’s fully saturated, then take your vape to the vape shop.
Step 00: Place an ice pack on top in the same way you did for your glass bowl.
Fill it up with a little water and slowly turn it over in your hands.
Steps 01-02: You’ll want to slowly slowly roll your vape into the glass bowl, with a rubber band on each end.
You’ll notice that the rubber bands do not completely cover the glass.
Step #03: Fill the bowl up with more water and gradually turn it around until the rubber band is completely covered.
You can still see the water on the rubber ring.
Step#04: Fill it up again with more and slowly rotate it around.
This time, the rubber rings will cover the bowl perfectly.
Step01: You should be vaping the bowl full of water.
It’s a bit of a shock to the system, but once you get used to the taste, you’ll be hooked.